=======================================================================================================================
1.0 [released 2024-03-15]
=======================================================================================================================
1.0.0.9 [available 2024-03-15]
prerequisite   Windows 10 (64 bit), English, version 1809 or newer
prerequisite   Microsoft .NET Framework 4.8 or newer
prerequisite   Keysight IO Libraries Suite 18.1 or newer
supported      Microsoft Excel rev. 2021, English
supported      Keysight Infiniium UXR-Series System Software rev. 11.50.00601
supported      Keysight M8195A Firmware and SFP rev. 4.2.2.0
supported      Keysight M8197A Firmware and SFP rev. 4.2.2.0
supported      Keysight UXR 4-channel oscilloscopes with sampling rates 128 GSa/s and 256 GSa/s
supported      Keysight M8195A three-module configuration
supported      MIPI D-PHY Specification 2.1 - CTS 1.0
new            Initial Release of N5991 MIPI D-PHY Test Automation.
new            Added the support of 8-Bit PRBS9 Sequence Generator as Errata 01 for MIPI D-PHY Specification.
bugfix         Fixed the issue of D-PHY Continuous CLK mode not working.
bugfix         Fixed the issue of sequence files (e.g. FrameStart.txt, FrameEnd.txt) missing from the installer.
bugfix         Fixed the issue that occurred when using the sample sequence file “Seq480pBTA.seq”.
bugfix         Fixed the issue of LP Calibration Clock failing with an error when LP data rate is set to 20Mbps.
bugfix         Fixed the issue of the indicated AWG Generators missing from the Connection Diagram for Multi-Lane setup.
bugfix         Fixed the issue of HS_Trail and HS_Exit durations not correct in the signal at lower data rates.
bugfix         Fixed the issue of Test 2.1.1 failing with an error when testing all data lanes simultaneously.
known issue    When a new ‘Configure DUT’ fails, the previously configured procedure tree is not removed.
known issue    When ValiFrame cannot start due to a missing license, in some corner cases the error message wrongly 
               indicates something else as the root issue.
information    The Skew calibration procedure randomly fails. In that case, the user can repeat the procedure to get a PASS.